NCEA Level 1 Engineering
Course Description
Teacher in Charge: Ms F. Matheson.
Develop as an engineer by making a set project and a project of your choice. Learn techniques including mig welding, centre lathe turning and sheet metal fabrication. Design and problem solve your own product from start to finish.
Contributions and Equipment/Stationery
Stationery Requirements: Pencil pack
Pathway
Credit Information
You will be assessed in this course through all or a selection of the standards listed below.
External
NZQA Info
Demonstrate basic engineering workshop skills under close supervision
NZQA Info
Develop a simple product using engineering materials
NZQA Info
Demonstrate knowledge of safety procedures in a specific engineering workshop
NZQA Info
Generic Technology 1.11 - Demonstrate understanding of basic human factors in design
NZQA Info
Construction and Mechanical Technologies 1.20 - Implement basic procedures using resistant materials to make a specified product
Pathway Tags
Disclaimer
Standards shown on courses are only an indication and not all may be offered at the time of study.